Changing Dash/Instrument Panel Bulbs

Remove both front A Post Door Pillars

Pull out at top, held in by Two Clips and then lift, Two locating tabs into Dash Top

Please note the clips can be sharp keep them away from other panels /seats they will scratch

Remove Centre Dash Console

(See Changing Head Unit for How To...Click Here)

Remove Two Screws (Circled Left)

Keeping reasonably level, Firmly Pull Top Dash away from Windscreen, again after removing screws it is only held in place by clips, about 3 each side (2 Circled Right)

You can either remove completely or just loosen.

(At this point you can change the heater control illumination bulbs if necessary remove screws to access bulbs (Blue Circle Left)

Pull down cover underneath Steering Wheel

Held in place by clips

Remove the Fuse Box/Mirror Switch Cover by undoing the Two Screws (Circled Left) and again firm pull has held in place by 3 Clips (Circled Right)

Remove Speedo Surround...again just firmly pull, held in place by clips only, the Air vent comes away with facia, you can make life easier by lower Steering Wheel position or even removing Steering Column Surround.

Take reasonable care has there is a wire loom for indicator warning lights

(At this point you can change these warning bulbs if necessary)

Remove the Four screws holding Speedo in place (Circled Left)...then pull the Instrument panel away...some resistance has the electrical connectors separate (Circled Right)

**Recommended to Disconnect Battery before removing Instrument Cluster**

Rear View of Instrument Cluster below

Bulbs 1—5 are illumination and Main beam warning is in Centre...to remove twist slightly (from Ten past Seven to Six O’Clock) and pull

You can create something a little different by replacing with coloured bulbs...I personally have replaced 1, 4 & 5 with Blue and 2 & 3 with Red.

Did start all Blue but couldn’t see dials, Red just seems to highlights needles a bit better

Take extra care when putting back together, make sure everything is aligned, especially the trip meter push rod with facia and clips with holes, and Remember the clips can be sharp keep them away from other panels /seats they will scratch